This post is from a suggested group
When dealing with the undead make sure you have the right kit. Lantac Dragon on the pointy end in 28 Years Later.
1277 Views
top of page
GROUP FEED
View groups and posts below.
This post is from a suggested group
Retro XM177E1 receivers are finished. More info soon....
1023 Views
This post is from a suggested group
Got to give the Onyx some appreciation. Love it
831 Views
This post is from a suggested group
XM177E1 (COLT 609) Replica.
Op1 is finished and we are moving onto Op2. More updates soon....
729 Views
This post is from a suggested group
Need a brake for your AK?
Check out JaegerZ999 and his zero recoil AK545 running our Lantac Dead Air Suppressor Mount with the same tech found in our DGNAK47B muzzle brake...
Full Video Here:
https://www.youtube.com/shorts/tPT2mLCdU20
This post is from a suggested group
L119A2 with a Lantac E-BCG Bolt Carrier Group. Way back in 2016...
This post is from a suggested group
3D Printing is a vital tool for product development.
Lantac LA-M4 Battle Raven in early stages of design.
.
This post is from a suggested group
Lantac Onyx Receiver Set...
This post is from a suggested group
You cannot purchase extruded 7075-T6 so these special project handguards were deep hole drilled and then wire EDM cut out of a massive block of 7075-T6. We then machined the outer surfaces and cut M-Lok slots. Probably the strongest handguards on the planet....
bottom of page
do they still use lantac bolts in their L119A2??